Heated Concrete
Radiant heat systems embedded in concrete driveways, walkways, and patios across Davis and Weber County. A heated concrete surface stays clear of snow and ice all winter without shoveling, salt, or scraping.
How in-slab radiant heat works and why Utah is a good fit
Radiant heat systems use either hydronic tubing (hot water circulated through PEX pipe) or electric resistance mats embedded in the concrete before it's poured. The heat radiates upward through the slab, warming the surface enough to melt snow and prevent ice formation. The concrete is poured over the tubing or mats — once it's down, the system is permanent. It cannot be added to existing concrete; it must be installed before the pour.
Davis County averages around 60 inches of snow per year. A heated driveway or front walkway means no early-morning shoveling, no deicing salt damaging the concrete surface, and no ice risk for vehicles and pedestrians. For properties where a main entry walk or a long driveway makes manual snow removal impractical, the upfront cost pays back in convenience and avoided maintenance. Heated driveways also eliminate the salt damage that's one of the leading causes of premature concrete deterioration in Utah.
Hydronic vs electric, and what each application calls for
Hydronic systems circulate hot water through PEX tubing. They have higher upfront cost (boiler or water heater, manifold, controls) but lower operating costs for large areas. Typical for driveways over 500 square feet where running electric heat year after year would be expensive. Electric mat systems are simpler to install and better suited for smaller areas — front walkways, steps, entryways, and portions of a patio. No boiler required; the mats connect to a circuit breaker and thermostat.
Both systems embed before the concrete pour and use the same process: tubing or mat is secured to the rebar grid, electrical and water connections are roughed in, and concrete is poured over the system. The concrete is finished and sealed the same way as any standard driveway pour. Smart controls can set the system to activate automatically based on outside temperature, so you don't have to remember to turn it on when weather is coming.
Heated Concrete Pricing in Utah
Heated concrete is priced as a base concrete pour plus the cost of the radiant system. The system cost depends on square footage, system type, and control complexity.
Base concrete pour (separate)
Standard 4-5 inch driveway or walkway pour
$10 – $20 / sq ft
Electric mat system (add-on)
Best for walkways, steps, and areas under 400 sq ft
$5 – $10 / sq ft added
Hydronic tubing system (add-on)
PEX tubing and manifold; requires boiler or heat source
$8 – $15 / sq ft added
Full heated driveway (system + pour, typical)
Includes controls, wiring or plumbing, and concrete
$25 – $50+ / sq ft
Planning a new driveway or walkway?
Radiant heat must be installed before the concrete pour. If you're already planning a new concrete surface, it's the right time to add it. Send us the details and we'll put together pricing.
Heated Concrete Questions
Common questions about radiant heat systems for driveways and walkways in Utah.
A heated concrete driveway typically runs $25 to $50 per square foot all-in — that includes the concrete pour ($10 to $20/sqft) plus the radiant system ($8 to $15/sqft for hydronic tubing, or $5 to $10 for electric mat, plus controls and electrical/plumbing work). A 400-square-foot driveway might cost $10,000 to $20,000 for a full heated system.
For most Utah homeowners with long driveways or mobility concerns, yes. The payback isn't primarily financial — it's the elimination of shoveling, deicing salt (which damages concrete and landscaping), and ice risk. If you're already pouring a new driveway, adding radiant heat is much cheaper than retrofitting it later. It also extends the life of the concrete by eliminating salt damage.
No. Radiant systems must be embedded before the concrete pour. There is no way to add in-slab heat to an existing concrete surface. If you want heated concrete, it requires a new pour. If your existing driveway is nearing replacement age, that's the right time to plan it into the new pour.
Depends on system type and how often it runs. A 400-square-foot electric mat system running 200 hours per winter season (rough estimate for Davis County) costs approximately $150 to $400 in electricity depending on your rate. Hydronic systems cost less per hour to operate for large areas but have higher upfront costs. Smart sensors that activate only when snow is falling significantly reduce operating cost versus manual or timer-based controls.
Electric resistance mats embedded in concrete have lifespans of 20 to 30+ years when correctly installed. PEX hydronic tubing has a rated lifespan of 50+ years. The concrete itself lasts 30 to 50 years. The control systems and mechanical components (boiler for hydronic) have shorter lifespans and will need replacement or maintenance over time, but the embedded elements are designed to outlast the slab.
Heated Concrete — Davis & Weber County
Never shovel again. Plan your heated driveway before the next pour.
What our clients say about heated concrete
Heated Concrete Service Areas in Utah
We serve Davis County, Weber County, Salt Lake County, and Utah County. Call us if you are unsure whether we cover your area.
How to get started.
Three simple steps from first call to finished job.
Contact Us
Complete the quick form to share your needs. We respond the same day — often within an hour.
Get free quote →Schedule Your Estimate
We'll arrange a visit at a time that works for you and provide an in-person, plain-english estimate.
Get free quote →Get the Job Done
Once approved, we schedule a date and work hard to exceed expectations. If it's not right, we come back.
Get free quote →